Show Control-Traffic Protocol - Dell C9000 Series Reference Manual

Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Usage Information This command applies the service-policy based on the type of protocol defined in the
ACL rules.
Create ACL and QoS policies prior to enabling this command.
If you configure rate-limiting of control protocols on a per-protocol basis and if you
modify the rate using the rate-police command in QOS-POLICY-IN mode while
traffic is being passed, packet drops for the specified protocols may occur if you
configure a rate higher than the default rate for a protocol.
Related
ip access-list extended cpu-qos
Commands
mac access-list extended cpu-qos
class-map cpu-qos
qos-policy-input cpu-qos
policy-map-input cpu-qos

show control-traffic protocol

Display per-protocol counters of rate-limited control-plane traffic.
C9000 Series
Syntax
show contol—traffic protocol [cp—switch | linecard slot-id portset
port-pipe | pe pe-id stack-unit unit-number portset port-pipe ]
counters
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
— creates an extended IP ACL for CoPP.
— creates an extended MAC ACL for CoPP.
— creates a QoS class map for CoPP.
— creates a QoS input-policy map for CoPP.
— creates an input-policy map for CoPP.
Control Plane Policing (CoPP) 666