Cam-Acl-Pe - Dell C9000 Series Reference Manual

cam-acl-pe

Allocate content addressable memory (CAM) for the port extender.
C9000 Series
Syntax
cam-acl-pe [default| l2acl number ipv4acl number ipv6acl number
ipv4qos number l2qos number ipmacacl number]
Parameters
default
l2acl
ipv4acl
ipv6acl
ipv4qos
l2qos
ipmacacl
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see
the relevant Dell Networking OS Command-Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
Usage Guidelines
Select the CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3 (IPv4)
QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for
DHCP, and Policy-based Routing (PBR). Save the new CAM settings to the startup-
config (write-memor copy run start) then reload the system for the new settings
to take effect. The total amount of space allowed is 12 FP Blocks. System flow requires
three blocks; these blocks cannot be reallocated.
The ipv4acl profile range is from 1 to 4. When configuring space foripv6acl, the
total number of Blocks must equal 13. Ranges for the CAM profiles are from 1 to 10,
except for the ipv6acl profile which is from 0 to 10. The ipv6acl allocation must be
a factor of 2 (2, 4, 6, 8, 10). If allocation values are not entered for the CAM regions, the
value is 0.
Resets ACL CAM entries to default setting.
Allocates space for the L2 ACL. The default value is 5.
Allocates space for the L3 ACL. The default value is 2.
Allocates space for the IPv6 L3 ACL. The default value is 2.
Allocates space for the L3 QoS. The default value is 2.
Allocates space for L2 QoS. The default value is 1.
(Optional) Allocates space for IP and MAC ACLs. The default
value is 0.
Description
Introduced on the C9010.
Content Addressable Memory (CAM) 649