Show Ip Igmp Groups - Dell Z9500 Command Reference Manual

Command INTERFACE
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.7(0.0)
9.5(0.0)
9.0.2.0
9.2(0.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
7.5.1.0

show ip igmp groups

View the IGMP groups.
Z9500
Syntax
show ip igmp [vrf vrf-name] groups [group-address [detail] |
detail | interface [group-address [detail]]]
Parameters
vrf vrf-name
group-address
interface
Internet Group Management Protocol (IGMP)
Description
Changed the default IGMP from version 2 to version 3.
Introduced on the S6000-ON
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the keyword vrf followed by the name of
the VRF to configure this setting on that VRF.
(OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
(OPTIONAL) Enter the interface type and slot/port
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
817