Show Ip Igmp Groups - Dell Force10 Z9000 Reference Manual

3
Defaults 2 (that is, IGMPv2)
Command Modes INTERFACE
Command History
Version 8.3.11.1
Version 8.3.7.0
Version 7.8.1.0
Version 7.7.1.0
Version 7.5.1.0

show ip igmp groups

View the IGMP groups.
C-Series, E-Series, S-Series, Z-Series, S4810
Syntax show ip igmp groups [group-address [detail] | detail |
interface [group-address [detail]]]
Parameters
group-address
interface
676
Enter the number 3 to set the IGMP version number to IGMPv3.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
(OPTIONAL) Enter the group address in dotted decimal format to view
information on that group only.
(OPTIONAL) Enter the interface type and slot/port information:
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port information.
• For a Port Channel interface, enter the keywords port-
channel followed by a number. For the C-Series and S-
Series, the range is 1 to 128. For the E-Series, the range is 1 to
255 for TeraScale and 1 to 512 for ExaScale.
• For a Loopback interface, enter the keyword loopback
followed by a number from 0 to 16383.
• For a SONET interface, enter the keyword sonet followed by
the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet followed by the slot/port
information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE followed by the slot/port information.
• For a VLAN interface enter the keyword vlan followed by a
number from 1 to 4094.