Dcb-Policy Output - Dell C9000 Series Reference Manual

The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.6(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information To associate a priority group with an ETS output policy with scheduling and bandwidth
configuration, create a DCB output policy. You can apply a DCB output policy on
multiple egress ports. When you apply an ETS output policy on an interface, ETS-
configured scheduling and bandwidth allocation take precedence over any configured
settings in QoS output policies.
The ETS configuration associated with 802.1 priority traffic in a DCB output policy is
used in DCBX negotiation with ETS peers.
Related dcb-map
Commands Ethernet traffic.

dcb-policy output

Apply the output policy with the ETS configuration to an egress interface.
C9000 Series
Syntax
dcb-policy output policy-name
To delete the output policy, use the no dcb-policy output command.
Parameters
policy-name
Defaults none
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Description
Introduced on the C9010.
Removed from the S-series. Replaced by the dcb-map
commands.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
— to configure PFC and ETS on Ethernet ports that support converged
Enter the output policy name.
Data Center Bridging (DCB) 698