Show Control-Traffic Queue - Dell C9000 Series Reference Manual

show control-traffic queue

Display per-queue counters of rate-limited control-plane traffic.
C9000 Series
Syntax
show contol—traffic queue {all | queue-id queue-number} counters
Parameters
all
queue-id queue-
number
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, refer
to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.9(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.8.0
Enter the keyword all to display counters for rate-limited traffic
on all CPU queues, including Route Processor, Control
Processor, and line-card CPUs.
Enter the queue number to display counters for rate-limited
traffic on a specified CPU queue. For the C9000 Series, the
range of queue-number values is from 0 to 20. The twenty-one
control–plane queues are divided into groups of seven queues
for the Route Processor, Control Processor, and line-card CPUs
as follows:
C9000 Series
• Queues 0 to 6 process packets destined to the Control
Processor CPU .
• Queues 7 to 13 process packets destined to the Route
Processor CPU.
• Queues 14 to 20 process packets destined to the line card
CPU.
Description
Introduced on the C9010.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Control Plane Policing (CoPP) 669