Show Ip Igmp Groups - Dell S6000 Reference Manual

Version 7.5.1.0

show ip igmp groups

View the IGMP groups.
S6000
Syntax
show ip igmp groups [group-address [detail] | detail |
interface [group-address [detail]]]
Parameters
group-address
interface
detail
Command
•
Modes
•
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Internet Group Management Protocol (IGMP)
Introduced on the E-Series.
(OPTIONAL) Enter the group address in dotted decimal
format to view information on that group only.
(OPTIONAL) Enter the interface type and slot/port
information:
• For a Port Channel interface, enter the keywords port-
channel then a number. The range is from 1 to 128.
• For a Loopback interface, enter the keyword loopback
then a number from 0 to 16383.
• For a 100/1000 Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitethernet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tengigabitethernet then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE then the slot/port information.
• For a VLAN interface enter the keyword vlan then a
number from 1 to 4094.
(OPTIONAL) Enter the keyword detail to display the
IGMPv3 source information.
EXEC
EXEC Privilege
Introduced on the S6000.
Introduced on the S4820T.
617