Reload Working - Alcatel-Lucent OmniSwitch 6250 Cli Reference Manual

reload working

Immediately reboots the primary CMM from the working directory. There is no CMM fail over during this
reboot, causing a loss of switch functionality during the reboot. All NIs reboot as well, including the
secondary CMM.
reload working {rollback-timeout minutes | no rollback-timeout} [in [hours:] minutes | at hour:minute]
Syntax Definitions
rollback-timeout minutes
no rollback-timeout
in [hours:] minutes
at hour:minute
Defaults
N/A
Platforms Supported
OmniSwitch 6250
Usage Guidelines
•
This command is used to reload the primary CMM from the working directory as opposed to the certi-
fied CMM. The working directory reload takes place immediately unless a time frame is set using the
in or at keywords.
•
The in or at keywords allow you to schedule a working reload sometime in the future. A schedule
working reboot is called an activate.
•
If a reload or an immediate working reload is initiated before a scheduled activate is enacted, a
message appears displaying the number of seconds until the scheduled activate and if it should be over-
ridden.
•
If a timeout is set, the switch reboots again after the set number of minutes, from the certified direc-
tory. The reboot can be halted by issuing a cancel order as described in the
page 1-4
Sets a timeout period, in minutes. The switch immediately reboots from
the working directory and then at the end of this time period, automati-
cally reboots again from the certified directory. The range is 1–15.
Specifies no timeout to rollback. If the command is issued with this
keyword, then the switch will continue to run from the working direc-
tory until manually rebooted.
Optional syntax. Schedules a reload of the working directory to take
effect in the specified minutes or hours and minutes within the next 24
hours.
Optional syntax. Schedules a reload of the working directory to take
place at the specified time using a 24-hour clock. If you do not specify
the month and day, the reload takes place at the specified time on the
current day provided the specified time is later than the time when the
CLI command is issued. If the specified time is earlier than the current
time, the reload will take place on the following day.
OmniSwitch 6250 CLI Reference Guide
CMM Commands
reload command.
November 2009