Checking The Fan Status; Checking The Power Supply Status; Automatic Monitoring; Additional Monitoring Commands - Alcatel-Lucent OmniSwitch 6250-M Hardware User's Manual

Monitoring the Chassis

Checking the Fan Status

To check the current status for all six fans in the chassis, use the
-> show fan
Chassis Fan Status
-------+---+-----------
1 1 Running
1 2 Running
1 3 Running
1 4 Running
For a complete list of output definitions for this command, refer to the OmniSwitch CLI Reference Guide.

Checking the Power Supply Status

For information on checking power supplies for OmniSwitch 6250 Series switches, refer to
Series Switches" on page

Automatic Monitoring

Automatic monitoring refers to the switch's built-in sensors that automatically monitor operations. The
switch recieves an interrupt warning at a temprature of 75C. It sends a trap to the user and the switch
shuts down automatically when the temperature reaches 80C. Upon cooling (at 65C), the switch restarts.

Additional Monitoring Commands

CLI Commands Used for Monitoring a Chassis
show cmm
show ni
show module
show module long
show module status
page 4-6
Preliminary
9/28/09
4-1.
Displays the basic hardware and status information for primary and
secondary management modules (if applicable).
Displays the basic hardware and status information for individual mod-
ules. If the switch is a standalone, information for the stand alone
switch displays.
Displays the basic information for individual modules. If the switch is a
standalone, information for the stand-alone switch displays.
Displays the detailed information for individual modules. If the switch
is a standalone, information for the standalone switch displays.
Displays the basic status information for individual modules. If the
switch is a standalone, information for the standalone switch displays.
OmniSwitch 6250 Series Hardware Users Guide
Booting 6250 Series Switches
show fan command. For example:
"Booting 6250
September 2009