Related Commands; Show Arp - Dell PowerConnect W-7200 Series Reference Manual

show arp

show arp
Description
Show Address Resolution Protocol (ARP) entries for the controller.
Syntax
No parameters
Example
This example shows configured static ARP entries for the controller.
(host) #show arp
Protocol
Internet
Internet
Internet
Internet
Internet
Internet
The output of this command includes the following parameters:
Parameter
Protocol
Address
Hardware Address
Interface

Related Commands

Add a static Address Resolution Protocol (ARP) entry using the command
Command History
This command was available in ArubaOS 3.0.
Command Information
Platforms
All platforms
908 | show arp
Address Hardware Address
10.3.129.98 00:1A:1E:C0:80:28
10.3.129.253 00:0B:86:42:35:80
10.3.129.250 00:1A:92:45:DB:00
10.3.129.99 00:1A:1E:C0:1C:60
10.3.129.96 00:1A:1E:C0:80:1E
10.3.129.254 00:0B:86:02:EE:00
Description
Protocol using ARP. Although the controller will most often use ARP to translate IP
addresses to Ethernet MAC addresses, ARP may also be used for other protocols, such
as Token Ring, FDDI, or IEEE 802.11, and for IP over ATM.
IP address of the device.
MAC address of the device.
Interface used to send ARP requests and replies.
Licensing
Base operating system
Interface
vlan1
vlan1
vlan1
vlan65
vlan65
vlan1
show arp.
Command Mode
Enable and Config mode on master and local
controllers
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide