Figure 3.33 Host Interface Setting Window; Table 3.29 Host Interface Setting Items - Fujitsu ETERNUS LT270 S2 User's Manual -Panel Operation

Chapter 3 Remote Panel Operation
3.11 Setting Library Information
2
A setting window for the selected adapter is displayed. From this window, settings for the
addressing mode, LOOP ID, and security can be made.

Figure 3.33 Host interface setting window

3
Make settings for each item.

Table 3.29 Host interface setting items

Setting item
Topology
Addressing Mode
LOOP ID
Link Speed
4
Click the [OK] button after all settings are completed. To restore the conditions before the
settings, click the [Reset] button.
5
After clicking the [OK] button, the system displays a confirmation window showing the
input contents. Click the [OK] button if it is OK to proceed. To make entries again, click the
[Back] button.
6
If processing is completed, the system displays a window showing the processing results. To
continue settings of the host interface, repeat the above procedure starting with
FUJITSU Storage ETERNUS LT270 S2 Tape Library User's Guide -Panel Operation-
Select from "Fabric" or "FC_AL".
This item is enabled if "FC_AL" is selected in Topology.
Select from "Hard" and "Soft."
This item needs to be specified if "Hard" is set as the Addressing Mode.
Link Speed is "Auto" and cannot be changed.
112
Copyright 2020 FUJITSU LIMITED
Explanation
Step 1.
P3AM-6932-06ENZ0