Modify Iscsi Port Parameters - Fujitsu ETERNUS DX S5 Series Configuration Manual

7. Host Interface Management
Modify Port Parameters

Modify iSCSI Port Parameters

This function sets the parameters for the iSCSI host interface port that connects between the ETERNUS DX and
the host.
Caution
When changing port parameters during operation, stop access from the server that is connected to the
target port. Host access does not need to be stopped to change the port parameters of newly added CA
ports.
The procedure to set iSCSI port parameters is as follows:
1
Select which iSCSI port to set the parameters for (multiple selections can be made) and click [Configure
iSCSI Port] in [Action].
The [Modify iSCSI Port Parameters] screen appears.
Note
• Multiple "1G iSCSI", "10G iSCSI", or "10G Base-T iSCSI" type iSCSI ports with the same port mode can
be selected.
• Multiple ports can be set with the same or with different parameters in a single operation. To set
parameters to multiple ports, select the target ports and specify the parameters for each port.
After the specification is complete, click the [Modify] button.
139 Configuration Guide (Basic)