Table of Contents
Advertisement
Chapter 7: Building the Trunk with the Default 10Gbps Stacking Ports
Adding Ports 25 and 26 on GS980MX/28 or GS980MX/28PSm
Switches to the Stack Trunk
Table 20. Adding Ports 25 and 26 to the Stack Trunk on the GS980MX/28 or GS980MX/28PSm
Step
1
Start a local management session on any switch in the stack. Refer to "Starting a
Local Management Session" on page 150.
2
Move to the Privileged Exec mode with the ENABLE command.
awplus> enable
3
Move to the Global Configuration mode with the CONFIGURE TERMINAL command.
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
4
Enter the port Interface mode for ports 25 and 26 on all of the GS980MX/28 or
GS980MX/28PSm switches in the stack. This example assumes the stack has four
switches:
awplus(config)# interface port1.0.25-1.0.26,port2.0.25-2.0.26,
port3.0.25-3.0.26,port4.0.25-4.0.26
Designate the ports as stacking ports with the STACKPORT command.
5
awplus(config-if)# stackport
% Save the config and restart the system for this change to take
effect.
Return to the Global Configuration mode.
6
awplus(config-if)# exit
154
This procedure explains how to add ports 25 to 26 to the stack trunk on
the GS980MX/28 or GS980MX/28PSm switch. The procedure assumes
the following:
You performed the procedures earlier in this chapter to power on
and verify the stack with ports 27 and 28 as the stack trunk.
Ports 25 to 26 are not cabled. If there are cables connected to the
ports, remove them before performing the procedure.
To add ports 25 and 26 to the stack trunk, perform the following
procedure:
Switch
Description and Command
Advertisement
Table of Contents
