Configure Vrrp Vlan Vrid Dont-Preempt - Extreme Networks ExtremeWare XOS Command Reference Manual

VRRP Commands

configure vrrp vlan vrid dont-preempt

configure vrrp vlan <vlan_name> vrid <vridval> dont-preempt
Description
Specifies that a higher priority backup router does not preempt a lower priority master.
Syntax Description
vlan_name
vridval
Default
The default setting is preempt.
Usage Guidelines
The preempt mode controls whether a higher priority backup router preempts a lower priority master.
dont-preempt
independent of the setting of this parameter.
Example
The following command disallows preemption:
configure vrrp vlan vlan-1 vrid 1 dont-preempt
History
This command was first available in ExtremeWare XOS 10.1.
Platform Availability
This command is available on all platforms.
1054
Specifies the name of a VRRP VLAN.
Specifies a VRRP Virtual Router ID (VRID). Value can be in the range of 1-
255.
prohibits preemption. The router that owns the virtual IP address always preempts,
ExtremeWare XOS 11.3 Command Reference