Mechanically Restricting The Working Range Of Axis 1 - ABB Robotics IRB 6790 Product Manual

2 Installation and commissioning

2.6.2 Mechanically restricting the working range of axis 1

2.6.2 Mechanically restricting the working range of axis 1
General
The working range of axis 1 is limited by fixed mechanical stops and adjustment
of the system parameter configuration. The working range can be reduced by
adding additional mechanical stops giving 7.5 or 15 graduation, between 22.5°
and 135° in both directions.
Mechanical stops, axis 1
The illustration shows the mounting position of the stop pin and one of the additional
mechanical stops available for axis 1.
xx1300001971
A
B
C
Continues on next page
90
A
Attachment screws M12x70 quality 12.9 Gleitmo 603 (2 pcs per additional
mechanical stop)
When the robot is used in a corrosive environment, the securing screws and
washers must be of stainless steel.
Movable mechanical stop
Mechanical stop pin axis-1
© Copyright 2019 - 2020 ABB. All rights reserved.
B
C
B
Product manual - IRB 6790
3HAC063331-001 Revision: B