Honda Accord 2008 Manual page 2122

07/11/02 09:29:21 61TA0000_220_0092
Battery Terminal Disconnection and Reconnection
Disconnection
NOTE: Some system store data in memory is lost when
the battery is disconnected. Do the following
procedures before disconnecting the battery.
1. Make sure you have the anti-theft code(s) for the
audio and/or the navigation system (if equipped).
NOTE: For some models, it maybe necessary to
write down the audio presets (AM and FM),
because the audio unit does not retain the presets
after the battery is disconnected.
2. Write down the XM audio presets (if equipped).
3. Make sure the ignition switch is in LOCK (0).
4. Disconnect and isolate the negative cable from the
battery.
NOTE: Always disconnect the negative cable from
the battery first.
5. Disconnect the positive cable from the battery.
Reconnection
NOTE: Some system store data in memory is lost when
the battery is disconnected. Do the following
procedures to restore the system back to normal
operation.
1. Clean the battery terminals.
2. Test the battery (see page 22-88).
3. Reconnect the positive cable (A) to the battery (B)
first, then reconnect the negative cable (C) to the
battery.
NOTE: Always connect the positive cable to the
battery first.
2.9 5.9 N·m −
−
(0.3 0.6 kgf·m, 2.1 4.4 lbf·ft)
A
4. Apply multipurpose grease to the terminals to
prevent corrosion.
5. Enter the anti-theft code(s) for the audio system
and/or the navigation system (if equipped).
6. Enter the audio presets (if applicable), and enter the
XM audio presets (if equipped).
7. Set the clock (for vehicles without navigation).
ＴＡ０８Ａ００Ｊ５４２０００１４４０１ＭＦＡＴ００
−
C
B
22-89
＊０１