Honda Accord 2008 Manual page 2130

07/11/02 09:29:27 61TA0000_220_0100
How to display DTCs on the gauge control module
Set the B-CAN System Diagnosis Test Mode 1 (see page 22-125). While in Test Mode 1, the DTCs which have been
detected and stored individually by various B-CAN (Body-controller Area Network) units, will be shown one by one on
the LCD display when the communication between the MICU and the gauge control module is normal. To scroll
through the DTCs, press the select/reset button.
＊０１
The unit that has stored the code can be identified by the number shown on the odometer display.
Driver's MICU
Passenger's MICU
Door multiplex control unit
Gauge control module
Climate control unit
HandsFreeLink control unit
Immobilizer-keyless control unit
How to clear the DTC
Set the B-CAN System Diagnosis Test Mode 1 (see page 22-125). While in Test Mode 1, press and hold down the
SELECT/RESET button for more than 10 seconds.
Control Unit Control Unit
I.D. Number
13
14
30
50
51
94
96
DTC detected (the lower four digits are
a decimal number representing the DTC)
No DTCs detected
All DTCs have been displayed
(cont'd)
22-97