Toyota Tundra 2005 Service - Repair - Maintenance page 2138

STARTING (1GR−FE) −
DISASSEMBLY
1. REMOVE REPAIR SERVICE STARTER KIT
(a) Remove the nut, and disconnect the lead wire from the re-
pair service starter kit.
A23149
(b) Remove the 2 screws which are used to secure the repair
service starter kit to the starter drive housing.
(c) Remove the repair service starter kit.
(d) Remove the return spring and plunger.
A23150
2. REMOVE STARTER YOKE ASSY
(a) Remove the 2 through bolts, and pull out the starter yoke
assy together with the commutator end frame assy.
3. REMOVE STARTER COMMUTATOR END FRAME
ASSY
(a) Remove the commutator end frame assy from the starter
yoke assy.
4. REMOVE STARTER ARMATURE PLATE
(a) Remove the starter armature plate from the starter yoke
A23151
assy.
5. REMOVE STARTER COMMUTATOR END FRAME
COVER
(a) Using a screwdriver, remove the cover.
6. REMOVE STARTER ARMATURE ASSY
(a) Using snap ring pliers, remove the snap ring and plate
washer.
(b) Remove the starter armature assy from commutator end
frame assy.
A23152
STARTER (1.6 kW)
ST−5
ST0PO−01