Exiting Any Of The Program Mode; Silencing An Alarm (Signal Horn); How To Arm The System Before Exiting - Siemens IC60 User Manual

Using the system
3.4

Exiting any of the program mode

3.5

Silencing an alarm (signal horn)

3.6

How to arm the system before exiting

10
Building Technologies
Fire Safety & Security Products
To EXIT any program mode, press <PROG> for 2 seconds.
1. Enter your PIN code.
2. Press <ENTER>
The <OK> indicator goes out, the system is now disarmed.
This stops the alarm at any time and also turns off any audible sirens. The outgo-
ing signals are stopped. This is the same procedure as disarming the system
Preparing the system for arming
Make sure that all zone indicators are off. All doors, exits and windows are closed
and motion in the protected area is restricted or bypassed. The system is ready to
be armed. The green indicator <OK> lights up. If one or more zone indicators are
illuminated, the open zones are indicated.
Close open zones or bypass them. Bypass any zone you cannot close. The <BYPASS> indicator
flashes indicating bypassed zone(s).
Warning Bypassed zones are not protected!
Arming the system
Before leaving the premises you must arm the system. Arming the alarm system
turns on all detectors in the zone/s that are armed.
Used keys: Arming with a code
1. Enter your PIN <CODE>.
2. Press <ENTER> to arm the system.
The <ARM> indicator lights up to indicate that the system is armed.
Quick ARM (when enabled at installation).
Used keys: Quick Arm
<ARM>
1. Press <ARM> to arm the system.
The <ARM> indicator lights up and the system is armed.
There is an exit delay prior to the system being armed. During this delay time, a slow beep sounds
to indicate that the system is not armed yet and to remind you to vacate the protected area. The
indicators may go out few seconds after exit delay times out, depending on the installation setting.
08.2007