Sensor Rotor Removal - Toyota Hilux Surf 1993 Owner's Manual

AT–92
AUTOMATIC TRANSMISSION
3. INSTALL NO.2 VEHICLE SPEED SENSOR
4. INSTALL PROPELLER SHAFT
(See page PR–3)
5. INSTALL NO. 1 VEHICLE SPEED SENSOR
(a) Install a new O–ring on the sensor.
(b) Install the No. 1 vehicle speed sensor.
6. CONNECT CONNECTOR
7. LOWER VEHICLE AND CHECK FLUID LEVEL
Start the engine, shift the shift lever into each position,
and then check the fluid level with the transmission in P
position.
Add fluid as necessary.
NOTICE: Do not overfill.
Fluid type: ATF DEXRONr 11
Sensor Rotor
REMOVAL OF SENSOR ROTOR
1. REMOVE EXTENSION HOUSING
(See page AT–90)
2. REMOVE SPEEDOMETER DRIVE GEAR
(a) Using snap ring pliers, remove the snap ring.
(b) Slide off the speedometer drive gear.
(e) Remove the lock ball.
3. REMOVE SENSOR ROTOR FROM OUTPUT SHAFT
– On–Vehicle Repair