Toyota Hilux Surf 1993 Owner's Manual page 479

TRANSFER – Assembly of Transfer
9. INSTALL OIL PUMP BODY ASSEMBLY
(a) Install the oil pump body assembly.
(b) Install and torque the three bolts.
Torque: 11 N–m (115 kgf–cm, 8 ft–lbf)
10. INSTALL SEPARATER WITH OIL STRAINER
(a) Coat a new O–ring with gear oil and install it to the
oil strainer pipe.
(b) Install the separater with the oil strainer.
(c) Install and torque the three bolts.
Torque: 18 N–m (185 kgf–cm, 13 ft–lbf)
11. INSTALL REAR OUTPUT SHAFT, DRIVEN SPROCKET
AND CHAIN
(a) Apply MP grease to the synchronizer ring (R150F,
G58).
(b) Align the synchronizer ring slots with the shifting
keys, and install it on the high and low clutch hub.
(c) Assemble the rear output shaft, driven sprocket and
chain.
(d) Mount the rear case in the vise.
NOTICE: Be careful not to damage the sealing sur-
face.
(e) Using a plastic hammer, tap the rear case with push–
ing the rear output shaft and driven sprocket.
HINT: If necessary, heat the rear case to about 70
(158 F).
E
(f) Using snap ring pliers, install the snap ring.
TF–67
C
E