Toyota Hilux Surf 1993 Owner's Manual page 424

TF–12
TRANSFER – Disassembly of Transfer
22. REMOVE INPUT GEAR AND COUNTER GEAR FROM
REDUCTION GEAR CASE
(a) Using a snap ring pliers, remove the two snap rings.
(b) Using a plastic hammer, tap out the input gear and
counter gear from the reduction gear case.
HINT: Place the reduction gear case on something soft
such as wooden blocks.
23. REMOVE OUTPUT SHAFT FROM FRONT CASE
(a) Remove the four bearing retainer bolts and remove
the bearing retainer.
(b) Using a snap ring pliers, remove the snap ring.
(c) Using a plastic hammer, tap out the output shaft
from the front case.
HINT: Place the front case on something soft such as
wooden blocks.
24. INSPECTION OF TRANSFER INDICATOR SWITCH
Check that there is continuity between terminals as
shown.
Switch Position
Push
Free
If operation is not as specified, replace the switch.
Specified
Continuity
No continuity