Toyota Hilux Surf 1993 Owner's Manual page 49

MT1–18
MANUAL TRANSMISSION –
11.–2 (22R–E)
REMOVE CLUTCH RELEASE CYLINDER, TUBE BRACKET
Remove the mounting bolts and lay the cylinder alongside
the engine.
HINT: Do not disconnect the clutch line.
12. (3VZ–E)
REMOVE THE FRONT DIFFERENTIAL SET BOLTS
(a) Remove the three bolts.
(b) Support the front differential.
13. REMOVE THE STABILIZER BRACKET SET BOLTS
Remove four bolts.
14. REMOVE NO.2 FRAME CROSSMEMBER FROM SIDE
FRAME
(a) Remove the four bolts from the engine rear mount–
ing.
(b) Raise the transmission slightly with a jack.
(c) Remove the eight bolts from the side frame and re–
move the No.2 frame crossmember.
15. (22R–E)
PLACE PIECE OF WOOD BETWEEN ENGINE OIL PAN
AND FRONT AXLE
16. LOW TRANSMISSION WITH TRANSFER
17. REMOVE STARTER
(a) Remove the two bolts.
(b) Lay the starter alongside the engine.
18. REMOVE EXHAUST PIPE BRACKET AND STIFFENER
PLATE BOLTS
19. REMOVE REMAINING TRANSMISSION BOLTS
20. REMOVE TRANSMISSION WITH TRANSFER
(a) Draw out the transmission with the transfer toward
the rear.
(b) Lower the transmission with the transfer front and
remove it from the vehicle.
Removal of Transmission with Transfer