Toyota Hilux Surf 1993 Owner's Manual page 133

MANUAL TRANSMISSION –
(c) Align the each bearing outer race, each fork shaft
If necessary, tap on the case with a plastic hammer.
30. INSTALL BEARING SNAP RINGS
Using a snap ring expander, install the two snap rings to
the input shaft bearing and counter gear front bearing.
31. INSTALL FRONT BEARING RETAINER
(a) Remove the any packing material and be careful not
to drop oil on the contacting surfaces of the front
bearing retainer or transmission case.
(b) Apply seal packing to the retainer as shown.
Seal packing: Part No. 08826–00090, THREE BOND
1281 or equivalent
(c) Apply liquid sealer to the bolt threads.
Sealant: Part No. 08833–00080, THREE BOND 1344,
LOCTITE 242 or equivalent
(d) Install and torque the bolts.
Torque: 17 N – m (170 kgf – cm, 12 ft – Ibf)
32.–1 (2WD)
INSTALL EXTENSION HOUSING, SHIFT AND SELECT
LEVER AND SHIFT LEVER HOUSING
(a) Remove the any packing material and be careful not
to drop oil on the contacting surfaces of the exten–
sion housing or transmission case.
(b) Apply seal packing to the extension housing as
shown.
Seal packing: Part No. 08826–00090, THREE BOND
1281 or equivalent
Assembly of Transmission
end and reverse idler gear shaft end with the case in–
stallation holes, and install the case.
MT1–103