TRANSFER
–
Component Parts (Rear Output Shaft Assembly)
5.–1 (MT)
INSTALL HIGH AND LOW HUB SLEEVE ASSEMBLY
(a) Using SST and a hammer, drive in a new key re–
tainer.
SST 09316–60010 (09316–00010)
NOTICE: Be careful not to deform or damage the key re–
tainer.
(b) Using a press, install the high and low hub sleeve as–
sembly.
5.–2 (AT)
INSTALL HIGH AND LOW HUB SLEEVE ASSEMBLY
Using a press, install the high and low hub sleeve assem–
bly.
6. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial
play.
Mark
(b) Using snap ring pliers, install the snap ring.
Thickness
mm (in.)
TF–55