AT–90
AUTOMATIC TRANSMISSION
REMOVAL OF EXTENSION HOUSING
1. RAISE VEHICLE AND POSITION PAN TO CATCH ANY
FLUID THAT MAY DRIP
2. REMOVE PROPELLER SHAFT
(See page PR–3)
3. JACK UP TRANSMISSION SLIGHTLY
Securely support the transmission on a transmission jack.
Lift the transmission slightly to remove weight from the
rear support member.
4. REMOVE NO. 1 VEHICLE SPEED SENSOR
(a) Disconnect the connector.
(b) Remove the bolt and pry out the No. 1 vehicle speed
(c) Remove the 0–ring from the sensor.
5. REMOVE NO.2 VEHICLE SPEED SENSOR
6. REMOVE ENGINE REAR MOUNTING FROM BRACKET
Remove eight bolts from the bracket.
–
On–Vehicle Repair
sensor with a screwdriver.