Front Axle Hub Disassembly, Inspection And Repair - Toyota Hilux Surf 1993 Owner's Manual

SA–12
SUSPENSION AND AXLE –
Front Axle Hub
(See page SA–11)
DISASSEMBLY OF FRONT AXLE HUB
1. REMOVE DISC BRAKE CYLINDER AND TORQUE PLATE
(a) Remove the brake cylinder and suspend it with wire.
(b) Remove the torque plate.
HINT: Do not disconnect the brake tube and hose.
2. REMOVE AXLE HUB WITH DISC
(a) (Single rear wheel)
Remove the cap.
(Double rear wheels)
Using SST, pry off the cap.
SST 09504–22011
(b) Remove the hub and disc together with the outer
bearing and thrust washer.
HINT: Be careful not to drop the outer bearing.
3. REMOVE INNER BEARING AND OIL SEAL
(a) Using a screwdriver, pry out the oil seal.
(b) Remove the inner bearing from the hub.
INSPECTION AND REPAIR OF FRONT AXLE HUB
1. INSPECT BEARING
Clean the bearings and outer races and inspect them for
wear or damage.
2. REPLACE BEARING OUTER RACE
(a) Using a brass bar and hammer, drive out the bearing
outer race.
Front Axle Hub and Steering Knuckle (Front Axle Hub)