Basic Subassembly Reassembly - Toyota Hilux Surf 1993 Owner's Manual

MT2–44
MANUAL TRANSMISSION –
COMPONENT PARTS INSTALLATION

BASIC SUBASSEMBLY REASSEMBLY

HINT: Coat all of the sliding and rotating surface with
gear oil before assembly.
1. INSTALL OUTPUT SHAFT TO INTERMEDIATE
PLATE
(a) Before installing the output shaft, use SST to remove
the counter gear center bearing outer race.
SST 09608–35014 (09608–06020, 09608–06090)
HINT: Install the outer race after installing the counter
gear.
(b) Install the output shaft into the intermediate plate by
pulling on the output shaft and tapping on the inter–
mediate plate.
2. INSTALL INPUT SHAFT AND COUNTER GEAR
(a) Apply gear oil to the needle roller bearing.
(b) Install the needle roller bearing to the input shaft.
(c) Install the input shaft and counter gear together.
(d) Using SST and a hammer, instal) the counter gear
center bearing outer race.
SST 09316–60010 (09316–00010)
HINT: Be careful not to damage the bearing rollers.
COMPONENT PARTS INSTALLATION