Lh Side Inspection And Replacement - Toyota Hilux Surf 1993 Owner's Manual

SUSPENSION AND AXLE –
9. CHECK RING GEAR RUNOUT
(a) Install the differential case onto the carrier and in–
stall the plate washers to where there is no play in
the bearing. (See page SA–97)
(b) Install bearing caps. (See page SA–99)
(c) Using a dial indicator, measure the runout of ring
gear.
Maximum runout: 0.07 mm (0.0028 in.)
INSPECTION AND REPLACEMENT OF LH SIDE
GEAR SHAFT
1. INSPECT CLUTCH HUB AND CLUTCH SLEEVE
(a) Check the wear and damage of the clutch hub and
clutch sleeve.
If necessary, replace them.
(b) Check that the clutch sleeve slides smoothly on the
clutch hub.
2. REMOVE CLUTCH HUB
(a) Using a snap ring expander, remove the snap ring.
(b) Remove the clutch hub from the side gear shaft.
3. REMOVE SIDE GEAR SHAFT FROM TUBE
(a) Remove the three bearing retainer bolts.
(b) Remove the side gear shaft from the tube.
4. REPLACE LH SIDE GEAR SHAFT BEARING
(a) Using a snap ring expander, remove the snap ring.
Front Differential (Disassembly and Assembly of
Differential w/ A D D )
SA–91