Toyota Hilux Surf 1993 Owner's Manual page 603

SUSPENSION AND AXLE –
17. INSTALL RH SIDE GEAR SHAFT
(a) Install a new snap ring to the side gear shaft.
(b) Using a plastic–faced hammer, tap on the side gear
shaft to install it.
18. CHECK INSTALLATION OF SIDE GEAR SHAFT
(a) Check that there is 2 – 3 mm (0.08 – 0.12 in.) of
play in axial direction.
(b) Check that the side gear shaft will not come out by
trying to pull it completely out by hand.
19. INSTALL INTERMEDIATE SHAFT
(a) Install a new snap ring to the shaft.
(b) Using a plastic–faced hammer, tap on the shaft to in–
stall it.
20. CHECK INSTALLATION OF INTERMEDIATE SHAFT
(a) Check that there is 2 – 3 mm (0.08 – 0.12 in.) of
play in axial direction.
(b) Check that the shaft will not come out by trying to
pull it completely out by hand.
21. INSTALL CLUTCH CASE TO SIDE GEAR SHAFT TUBE
(a) Install a new O–ring to the tube.
(b) Coat the 0–ring with MP grease.
(c) Install the clutch case to the tube.
(d) Tighten the two torx bolts.
Torque: 78 N¿ m l800 kgf–cm, 58 ft¿ Ibf j
Torx wrench: E14 (Part No. 09044–00010 or locally
manufactured tool)
22. INSTALL CLUTCH SLEEVE
Front Differential (Disassembly and Assembly of
Differential w/ A D D )
SA–103