Toyota Hilux Surf 1993 Owner's Manual page 580

SA–80
SUSPENSION AND AXLE –
(a) If the preload is greater than specification, replace
the bearing spacer.
(b) If the preload is less than specification, retighten the
nut 13 N–m (130 kgf–cm, 9 ft–lbf) a little at a time
until the specified preload is reached.
Maximum torque: 223 N–m (2,275 kgf–cm, 165 ft–lbf)
If the maximum torque is exceeded while retightening the
nut, replace the bearing spacer and repeat the preload
procedure. Do not back off the pinion nut to reduce the
preload.
14. CHECK RUNOUT OF COMPANION FLANGE
Using a dial indicator, measure the vertical and lateral
runout of the companion flange.
Maximum vertical runout: 0.10 mm 10.0039 in.)
Maximum lateral runout: 0.10 mm (0.0039 in.)
If the runout is greater than maximum, inspect the
bearings.
15. STAKE DRIVE PINION NUT
16. INSTALL NEW SIDE GEAR SHAFT OIL SEAL
(a) Coat the oil seal lip with MP grease.
(b) Using SST, drive in the oil seal until it is flush with
the carrier end surface.
SST 09550–22011 (09550–00020, 09550–00031)
Front Differential (Disassembly and Assembly of
Differential w/o A D D )