Rear Axle Shaft Installation - Toyota Hilux Surf 1993 Owner's Manual

SA–126
SUSPENSION AND AXLE –
INSTALLATION OF REAR AXLE SHAFT
(See page SA–123)
1. INSTALL REAR AXLE SHAFT IN BACKING PLATE
(a) Apply MP grease to the oil seal lip.
(b) Install the backing plate and bearing retainer on the
rear axle shaft.
(c) Using SST, press the rear axle shaft into the backing
plate.
SST 09515–30010
(d) Using snap ring pliers, install a new snap ring.
2. INSTALL REAR AXLE SHAFT INTO HOUSING
Install the rear axle with four nuts.
Torque: 59 N–m (700 kgf–cm, 51 ft–lbf)
HINT:
Be careful not to damage the oil seal.
•
When inserting the axle shaft, be careful not to hit or
•
deform the oil deflector inside the axle housing.
3. CONNECT BRAKE TUBE AND PARKING BRAKE CABLE
4. INSTALL BRAKE DRUM AND WHEEL
5. BLEED BRAKE SYSTEM
Rear Axle Shaft (Single Tire)