Disassembly Of Combination Switch - Toyota Hilux Surf 1993 Owner's Manual

BODY ELECTRICAL SYSTEM

Disassembly of Combination Switch

NOTICE: w/ Cruise Control System
To prevent damage to the slip ring when removing the
steering wheel, be careful of the following points.
• Keep the steering wheel in the "straight–ahead" steer–
ing position.
• Do not let the steering wheel strongly interfere with
the connector part of the slip ring.
1. REMOVE WIRE HARNESS CLAMP FROM WIRE
HARNESS
Pry loose– the two locking lugs and remove the clamp
from the wire harness.
2. REMOVE TERMINALS FROM CONNECTOR
(a) Release four tabs and open the terminal cover.
3. (w! Cruise Control System)
REMOVE SLIP RING
Remove four screws and the slip ring from the switch
body.
4. REMOVE LIGHT CONTROL SWITCH
(a) Remove two screws and the ball set plate from the
(b) Remove the ball and slide out the switch from the
– Lighting System
(b) From the open end, insert a miniature screwdriver
between the locking lug and terminal.
(c) Pry down the locking lug with the screwdriver and
pull the terminal out from the rear.
switch body.
switch body with the spring.
BE–17