Toyota Hilux Surf 1993 Owner's Manual page 185

MANUAL TRANSMISSION –
13. INSTALL SPACER AND BEARING
(a) Install the spacer.
(b) Using a socket wrench and hammer, drive in the
bearing.
HINT: When driving in the bearing, support the cou–
nter shaft in front with a 3–5 Ib hammer or equiva–
lent.
14. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
Mark
(b) Using a snap ring expander, install the snap ring.
15. INSPECT COUNTER FIFTH GEAR THRUST CLEAR–
ANCE
Using a feeler gauge, measure the counter 5th gear
thrust clearance.
Standard clearance:
0.10–0.41 mm (0.0039–0.0161 in.)
16. INSTALL SPEED SENSOR DRIVE GEAR
(a) Put a clip on the output shaft and install the drive gear
clip into the slot.
(b) Slide the drive gear with clip and fit the clip into the
holes.
COMPONENT PARTS INSTALLATION
Thickness mm (in.)
MT2–48