Toyota Hilux Surf 1993 Owner's Manual page 633

SUSPENSION AND AXLE –
(f) Using a spring tension gauge, measure and note fric–
tion force of the oil seal. (starting)
(g) Using SST, tighten the bearing lock nut until the pre–
load is within the specification below.
SST 09 509–2 5011
Preload (starting):
Add oil seal frictional force
(h) Align the lock nut mark with one of the marks on the
axle housing, and place lock bolts in the holes at
right angles to the lock nut.
(i) Measure the distance between the top surface of
axle housing and the lock nut.
Standard distance: – 0.2 to 0.9 mm
If not within specification, reinstall the axle hub.
(j) Check the movement of the drum.
(k) Check that has no axle play.
6. INSTALL REAR AXLE SHAFT
(See page SA–128)
7. INSTALL WHEEL AND LOWER VEHICLE
Rear Axle Shaft and Axle Hub (Double Tire)
1.0 –14.7 N (0.1 –1.5 kgf, 0.2 –3.3 Ibf )
(– 0.008 to 0.035 in.)
SA–133