Toyota Hilux Surf 1993 Owner's Manual page 510

SUSPENSION AND AXLE –
5. ADJUST WHEEL ANGLE
Remove the caps of the knuckle stopper bolts and check
the steering angles.
Max.
at 200
(outside wheel)
HINT: When the steering wheel is fully turned, make
sure that the wheel is not touching the body or brake
flexible hose.
If maximum steering angles differ from standard value,
adjust the wheel angle with the knuckle stopper bolts.
Torque: 47 N–m (480 kgf–cm, 35 ft–lbf)
If the wheel angle still cannot be adjusted within limits,
inspect and replace damaged or worn steering parts.
6. INSPECT TOE–IN
Toe–in: See page A–26
If toe–in is not within specification adjust by the tie rod
end.
7. ADJUST TOE–IN
(a) Loosen the clamp bolts and nuts.
(b) Adjust toe–in by turning the left and right tie rod
tubes an equal amount.
Toe–in: See page A–26
(c) Insure that the lengths of the left and right tie rods
are equal.
NOTICE: Check that the steering wheel is straightened.
Wheel Alignment (4WD)
Wheel angle
Inside wheel
Outside wheel
Inside wheel
SA–9
32E 00' +1 E
E
–2
31E
21 E 10'