SR–26
STEERING
–
Manual Gear Housing (4WD)
MANUAL GEAR HOUSING (4WD)
REMOVAL AND INSTALLATION OF MANUAL
GEAR HOUSING
Remove and install the parts as shown.
(MAIN POINTS OF REMOVAL AND
INSTALLATION)
1. DISCONNECT UNIVERSAL JOINT
(a) Loosen the column side set bolt.
(b) Remove the gear side set bolt.
(e) Place matchmarks on the universal joint and worm
shaft.
(d) Slide the shaft rearward to disconnect the shaft
from the worm shaft.
2. DISCONNECT PITMAN ARM FROM GEAR HOUSING
(a) Loosen the pitman arm set nut.
(b) Using SST, disconnect the pitman arm from the gear
housing.
SST 09628–62011