MANUAL TRANSMISSION
–
(f) Select a snap ring that will allow minimum axial play.
Mark
(g) Using a snap ring expander, install the snap ring.
2. IF NECESSARY, REPLACE COUNTER GEAR
CENTER BEARING
(a) Remove the bearing from the counter gear.
(b) Install a new bearing on the counter gear.
HINT: Engage the roller cages.
(c) Using SST, tap out the bearing outer race.
SST 09608–35014 (09608–06020, 09608–06090)
HINT: The outer race will be installed later, as the
transmission is assembled.
COUNTER GEAR COMPONENT PARTS
ASSEMBLY
1. INSTALL SYNCHRONIZER RING ASSEMBLY TO
NO.3 HUB SLEEVE
(a) Push the synchronizer spring, install the shifting key
and key spring to reverse synchronizer ring.
COUNTER GEAR AND REVERSE IDLER GEAR
Thickness mm (in.)
MT2–37