Toyota Hilux Surf 1993 Owner's Manual page 527

SUSPENSION AND AXLE –
7. REMOVE LOWER SUSPENSION ARM
Remove the nut and lower suspension arm.
REPLACEMENT OF LOWER ARM BUSHING
1. REMOVE BUSHING
(a) Cut off the bushing rubber as shown in the figure.
(b) Using SST, remove the bushing.
SST 09726–35010
2. INSTALL BUSHING
(a) Apply soapy water on the front rubber part of the
bushing and fit SST on the new bushing.
SST 09726–35010
(b) Using SST, install the new bushing.
SST 09726–35010
INSTALLATION OF LOWER SUSPENSION ARM
AND SHOCK ABSORBER
1. INSTALL LOWER SUSPENSION ARM
(a) Install the torque arm mounting bolts to the lower
arm.
(b) Place the torque arm on the lower arm shaft.
Set the lower arm in installation position, and install
the lower arm shaft and torque arm.
(c) Temporarily install the torque arm.
(d) Finger tighten the lower arm, and remove the torque
arm.
HINT: Do not torque the nut.
2. CONNECT LOWER BALL JOINT
Connect the lower ball joint to the lower suspension arm
with the three bolts.
Torque: 127 N–m (1,300 kgf–cm, 94 ft–Ibf)
Front Suspension (Lower Suspension Arm and Shock
Absorber)
SA–23