MANUAL TRANSMISSION
–
6. INSTALL FIFTH GEAR AND OUTPUT SHAFT REAR
BEARING
Using SST, install the 5th gear and rear bearing.
SST 09312–20011 (09313–00010, 09313–00030,
09313–00040, 09313–00050)
7. INSTALL SNAP RING
(a) Select a snap ring that will allow minimum axial play.
Mark
(b) Using a screwdriver and hammer, tap in the snap ring.
8. INSTALL REAR MAGNET
9. INSTALL NO.3 CLUTCH HUB
Using SST and a hammer, drive in No.3 clutch hub.
SST 09316–60010 (09316–00010, 09316–00070)
HINT: When installing the clutch hub, support the
counter shaft in front with a 3–5 Ib hammer or
equivalent.
COMPONENT PARTS INSTALLATION
Thickness mm (in.)
MT2–46