Toyota Hilux Surf 1993 Owner's Manual page 638

SA–138
SUSPENSION AND AXLE –
6. CHECK TOTAL PRELOAD
Using a torque meter, measure the total preload.
Total preload (starting):
Add drive pinion preload
7. REMOVE COMPANION FLANGE
(a) Using a hammer and chisel, loosen the staked part
of the nut.
(b) Using SST to hold the flange, remove the nut.
SST 09330–0002 1
(c) Using SST, remove the companion flange.
SST 09557–22022
( 7.5 in. 09557–22030)
(8 in. 09557–22050)
8. REMOVE OIL SEAL AND OIL SLINGER
(a) Using SST, remove the oil seal from the housing.
SST 09308–10010
(b) Remove the oil slinger.
9. REMOVE FRONT BEARING AND BEARING SPACER
(a) Using SST, remove the front bearing from the drive
pinion.
SST 09556–30010
(b) Remove the bearing spacer.
If the front bearing is damaged or worn, replace the bear–
ing.
Differential
0.4 – 0.6 N–m (4 – 6 kgf–cm, 3.5 – 5.2 in.–Ibf)