Release Cylinder Inspection; Relase Cylinder Assembly; Release Cylinder Installation - Toyota Hilux Surf 1993 Owner's Manual

CLUTCH – Clutch Release Cylinder
INSPECTION OF RELEASE CYLINDER
HINT: Clean the disassembled parts with compressed
air.
1. INSPECT RELEASE CYLINDER BORE FOR SCORING OR
CORROSION
If a problem is found, clean or replace the cylinder.
2. INSPECT PISTON AND CUPS FOR WEAR, SCORING,
CRACKS OR SWELLING
If either one requires replacement, use the parts from the
cylinder kit.
3. INSPECT PUSH ROD FOR WEAR OR DAMAGE
If necessary, replace the push rod.
ASSEMBLY OF RELEASE CYLINDER
(See page CL–10)
1. COAT PISTON WITH LITHIUM SOAP BASE GLYCOL
GREASE, AS SHOWN
2. INSTALL PISTON
3. INSTALL BOOT AND INSERT PUSH ROD
INSTALLATION OF RELEASE CYLINDER
(See page CL–10)
1. INSTALL RELEASE CYLINDER WITH TWO BOLTS
Torque: 12 N–m (120 kgf–cm, 9 ft–lbf)
2. CONNECT CLUTCH LINE UNION
Using SST, connect the union.
SST 09751–36011
3. BLEED CLUTCH SYSTEM
(See page CL–4)
CL–11