Toyota Hilux Surf 1993 Owner's Manual page 621

SUSPENSION AND AXLE –
7. TORQUE UPPER ARM SHAFT
(a) Install the retainers and new nuts.
HINT: Position the upper arm shaft so that the frame in–
stallation surface is level with the arm.
(b) Torque the shaft nuts.
Torque: 226 N–m (2,300 kgf–cm, 166 ft–Ibf )
(c) Stake the nuts with a hammer and chisel.
8. INSTALL TORQUE ARM TO UPPER ARM
Torque: 87 N–m (890 kgf–cm, 64 ft–lbf)
INSTALLATION OF UPPER SUSPENSION ARM
1. INSTALL UPPER SUSPENSION ARM TO FRAME
(a) Install the lower suspension arm to the frame and
torque the mounting bolts.
Torque: 178 N–m (1,810 kgf–cm, 131 ft–lbf)
(b) Connect the intermediate shaft to the steering gear
housing.
2. CONNECT SHOCK ABSORBER TO FRAME
Connect the shock absorber to frame with cushion and
retainer and install and torque a new nut as shown in the
figure.
Torque: 25 N–m (250 kgf–cm, 18 ft–lbf)
Front Suspension (Upper Suspension Arm)
SA–121