Toyota Hilux Surf 1993 Owner's Manual page 379

AT–182
AUTOMATIC TRANSMISSION
3. INSPECT THROTTLE CABLE
(a) Depress the accelerator pedal all the way and check
HINT: If the valve does not open fully, adjust the accel–
erator cable.
(b) Fully depress the accelerator pedal.
(c) Measure the distance between the end of the boot
4. INSPECT TRANSMISSION SHIFT LEVER POSITION
When shifting the shift lever from the N position to other
position, check that the lever can be shifted smoothly
and accurately indicates the position.
If the indicator is not aligned with the correct position,
carry out the following adjustment procedures.
(a) Loosen the nut on the shift lever.
(b) Push the control shaft lever fully rearward.
(c) Return the control shaft lever two notches to N pos–
(d) Set the shift lever to N position.
(e) While holding the shift lever lightly toward the R po–
(f) Start the engine and make sure that the vehicle
5. INSPECT PARK/NEUTRAL POSITION SWITCH
Check that the engine can be started with the shift lever
only in the N or P position, but not in other positions.
If not as started above, carry out the following adjust–
ment procedures.
(a) Loosen the park/neutral position switch bolt and set
(b) Align the groove and neutral basic line.
(c) Hold in position and tighten the bolt.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)
6. INSPECT IDLE SPEED (N POSITION)
Connect a tachometer test probe, to the data link con–
nectar 1 terminal IG (–), inspect the idle speed.
Idle speed: 850 RPM
– Troubleshooting (Preliminary Check)
that the throttle valve opens fully.
and stopper on the cable.
Standard distance: 0–1 mm (0–0.04 in.)
If the distance is not standard, adjust the cable by the
adjusting nuts.
tion.
sition side, tighten the shift lever nut.
moves forward when shifting the lever from the N to
D position and reverse when shifting it to the R po–
sition.
the shift lever to the N position.