Stabilizer Bar - Toyota Hilux Surf 1993 Owner's Manual

SA–28
SUSPENSION AND AXLE –

Stabilizer Bar

(See page SA–17)
REMOVAL OF STABILIZER BAR
1. REMOVE ONE TORSION BAR SPRING
(See page SA–20)
2. REMOVE STABILIZER BAR FROM LOWER ARMS
(a) Remove the nuts and cushions holding both sides of
the stabilizer bar from the lower arms, and discon–
nect the stabilizer bar.
(b) Remove both stabilizer bar bushings and brackets,
and remove the stabilizer bar.
INSTALLATION OF STABILIZER BAR
1. PLACE STABILIZER BAR TO FRAME
Place the stabilizer bar in position and install both stabi–
lizer bar bushings and brackets to the frame.
Finger tighten the bolts.
2. CONNECT STABILIZER BAR TO LOWER ARMS
Connect the stabilizer bar on both sides to the lower arms
with bolts, cushions and new nuts as shown. Torque the
nuts.
Torque: 13 N–m (130 kgf–cm, 9 ft–lbf)
3. TORQUE BRACKET SET BOLTS
Torque: 29 N–m (300 kgf–cm, 22 ft–lbf)
4. INSTALL TORSION BAR SPRING
(See page SA–20)
Front Suspension (Stabilizer Bar)