Toyota Hilux Surf 1993 Owner's Manual page 649

SUSPENSION AND AXLE –
If the teeth are not contacting properly, use the following
chart to select a proper washer for correction.
Washer thickness
10. REMOVE COMPANION FLANGE
(See step 7 on page SA–138)
11 REMOVE FRONT BEARING
(See step 9 on page SA–138)
12. INSTALL NEW BEARING SPACER AND FRONT BEARING
(a) Install a new bearing spacer on the shaft.
(b) Install the front bearing on the shaft.
13. INSTALL OIL SLINGER AND NEW OIL SEAL
(a) Install the oil slinger facing as shown.
(b) Using SST, drive in a new oil seal as shown.
SST 09554–30011
Oil seal drive in depth:
7.5 in. 1.5 mm (0.059 in.)
8 in. 1.0 mm (0.039 in.)
(c) Apply MP grease to the oil seal lip.
14. INSTALL COMPANION FLANGE
(a) Install the companion flange with SST.
SST 09557–22022
(7.5 in. 09557–22030)
(8 in. 09557–22050)
Differential
SA–149