Toyota Hilux Surf 1993 Owner's Manual page 550

SA–50
SUSPENSION AND AXLE –
(d) Using a snap ring expander, install a new snap ring.
5. ASSEMBLE BOOT TO OUTBOARD JOINT
Before assembling the boot, pack in grease.
HINT: Use the grease (black) supplied in the boot kit.
Grease capacity: 195 – 205 g (0.43 – 0.45 Ib)
6. ASSEMBLE INBOARD JOINT TO INBOARD JOINT TULIP
(a) Pack in grease to the inboard tulip and boot.
HINT: Use the grease (brown) supplied in the boot kit.
Grease capacity: 270 – 280 g (0.60 – 0.62 Ib)
(b) Align the matchmarks placed before disassembly.
(c) Install the inboard tulip to the drive shaft.
(d) Temporarily install the boot to the inboard tulip.
7. ASSEMBLE NEW BOOT CLAMPS TO BOTH BOOTS
(a) Be sure the boot is on the shaft groove.
(b) Bend the band and lock it as shown in the figure.
Front Drive Shaft