Stabilizer Bar Removal And Installation - Toyota Hilux Surf 1993 Owner's Manual

SA–122
SUSPENSION AND AXLE –
3. CONNECT UPPER SUSPENSION ARM TO UPPER BALL
JOINT
(a) Connect the upper ball joint to the steering knuckle
and install and torque the nut.
Torque: 142 N–m (1,450 kgf–cm, 105 ft–lbf)
(b) Install a new cotter pin.
4. INSTALL TORSION BAR SPRING
(See page SA–114)
5. CHECK FRONT WHEEL ALIGNMENT
(See page SA–6)
Stabilizer Bar
(See page SA–111)
REMOVAL OF STABILIZER BAR
REMOVE STABILIZER BAR
(a) Remove the nut, cushions and retainers holding
both sides of the stabilizer bar from the lower sus–
pension arms, and disconnect the stabilizer bar.
(b) Remove both stabilizer bar brackets and cushions,
and remove the stabilizer bar.
INSTALLATION OF STABILIZER BAR
1. PLACE STABILIZER BAR TO FRAME
Place the stabilizer bar in position and install the both sta-
bilizer bar cushion and brackets to the frame. Temporarily
install the bolts.
2. CONNECT STABILIZER BAR TO LOWER SUSPENSION
ARMS
Connect the stabilizer bar on both sides to the lower arms
with bolts, cushion, retainers and a new nut as shown.
Torque the nut.
Torque: 25 N–m (260 kgf–cm, 19 ft–lbf)
3. TORQUE BRACKET SET BOLTS TO FRAME
Torque: 29 N–m (300 kgf–cm, 22 ft–lbf)
Front Suspension (Upper Suspension Arm, Stabilizer
Bar)