Toyota Hilux Surf 1993 Owner's Manual page 113

MANUAL TRANSMISSION –
(c) Using a dial indicator, check the shaft runout.
Maximum runout: 0.06 mm (0.0024 in.)
If the runout exceeds the maximum, replace the output
4. INSPECT SYNCHRONIZER RINGS
(a) Turn the ring and push it in to check the braking ac–
(b) Using a feeler gauge, measure the clearance be–
Standard clearance: 0.8 – 1.6 mm
Minimum clearance: 0.6 mm (0.024 in.)
If the clearance is less than the minimum, replace the
synchronizer ring.
5. INSPECT CLEARANCE OF SHIFT FORKS AND HUB
SLEEVES
Using a feeler gauge, measure the clearance between the
hub sleeve and shift fork.
Maximum clearance: 1.0 mm (0.039 in.)
If the clearance exceeds the maximum, replace the shift
fork or hub sleeve.
Component Parts (Output Shaft Assembly)
shaft.
tion.
tween the synchronizer ring back and the gear spline
end.
(0.031 – 0.063 in.)
MT1–83