Toyota Hilux Surf 1993 Owner's Manual page 514

SUSPENSION AND AXLE –
If camber caster is not within specification, adjust by
adding or removing shims on the upper arm.
Shim thickness mm (in. )
If the steering axis inclination is not as specified after
camber and caster have been correctly adjusted, recheck
the steering knuckle and front wheel for bending or loose–
ness.
6. INSPECT TOE–IN
Toe–in: See page A–23
If toe–in is not within specification adjust by the tie rod
end.
7. ADJUST TOE–IN
(a) Loosen the clamp bolts.
(b) Adjust toe–in by turning the left and right tie rod
tubes an equal amount.
Toe–in: See page A–23
HINT: Make sure that the tie rods are the same length.
Left–right error: 3.0 mm (0.118 in.) or less
(g) Tighten the clamp bolts and torque them.
Torque: 25 N–m (260 kgf–cm, 19 ft–Ibf)
8. INSPECT SIDE SLIP (REFERENCE ONLY)
Side slip: 3.0 mm/m (0.118 in. I3.3 ft) or less
Wheel Alignment (2W–D)
Thickness
4.0
1.6
1.2
SA–5
(0.157)
(0.063)
(0.047)